TapeDrive

BROTHER HL 2400C DRIVERS DOWNLOAD

May 13, 2018

First Transfer Process Refer to Fig. An error occurred in the Turn off the printer, and re- optional font card. Main Causes 1 Installation failure of the transfer unit, and deformation of the transfer roller. This printer is old, launching in November Fast page or EDO automatic selection Access time:

Uploader: Juhn
Date Added: 2 May 2018
File Size: 24.68 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 43373
Price: Free* [*Free Regsitration Required]

The label brothee below is attached in countries where required. Page 1 Check that specified paper is used. The following 2 bytes should be the 16 bit data to repeat.

Brother HLC series – Free download and software reviews – CNET 01

Go to the next step. When the power save mode is turned on, the printer turns on the fixing assembly again automatically after it receives data from brother hl – 2400c computer. The font is temporarily stored in the RAM of the printer before it is saved on the card. If the same error 24000c occur after you press the Continue button, turn off the printer.

To control the sequence of processes of the printer: Pressing the Continue button may ignore the error and resume brother hl – 2400c operation. The numbers at the top of the table are hexadecimal code values with which characters are to be replaced in the US ASCII character set. By pressing ‘print’ button you will brother hl – 2400c only current page. You can set the resolution in this mode according to your requirement.

Or turn off the printer, wait for a few seconds, and turn it on again. The Alarm LED is blinking. Reset the printer with the Reset button. When you see brother hl – 2400c message, you need to replace the Gl Toner Pack.

Brother HL-2400C Service Manual

A number of repeats 13 bits Page Bently brother hl – 2400c Los Angeles. Main Causes Fusing failure due brothr using damp paper or using the printer under high humidity conditions. Page 3 Brother products. The auto modes are not available. Replacing the Fusing Unit 1. Between the cartridge cover and developer roller a On the surface of the hp roller b Page White Line 2 Phenomenon Vertical white line appears from the leading edge to the trailing edge of the printed image brother hl – 2400c shown in print sample 7 of Fig.

Wait approximately 30 minutes before exchanging consumables that are in the area of the Fusing unit. An additional Lower Tray Unit is available as an option.

If the optional font card is installed, you can print out the list of optional fonts. The number of characters for bar codes is limited as follows.

Brother HLC Driver Download for Windows 10, 7, 8/ – Drivers Update Center

Close the Front Cover. If you set the mode to AUTO, the brother hl – 2400c attempts to resume the operation without pressing the Continue button. Caution Do not touch the memory chips and the surface of the main controller board. Failure to do so will cause toner or oil spill in the printer and severe damage to the printer.

Release the green Transfer Roller Lock Lever.

Therefore you cannot feed irregular sized paper in the usual way. The installation order of the four toner cartridges should be from the bottom to the top, in terms of colors this is in the order Cyan CMagenta MYellow Yand Black Brother hl – 2400c. Close the Top 24400c.